I have two routers linked via Frame Relay / ATM combination WAN. At the FRA end router (2620), SH IPX SERVER command displays 273 IPX servers. The ATM end router (2620) however displays only 148 IPX servers. Therefore IPX SAPs must be lost along this path.
I have another similar WAN link working OK and noticed the FRA end router feature set includes "PLUS" features.
I upgraded the FRA end router on the problem link from c2600-d-mz.12.1-14 (IP/IPX/AT/DEC) to c2600-ds-mz.12.1-14 (IP/IPX/AT/DEC/PLUS) and the problem was corrected. Whew. Success. But WHY?
The "Software Advisor", "Compare Releases", list of Features Unique to the "PLUS" version does not include any reference to IPX or SAP. What is it about the PLUS features that ensures sending of SAPs?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...