Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

why policy is not showing on config ??

I did the Qos with LLQ separate video and audio, but once I apply it to pvc, it does not show on config neither on "sho policy int"

any idea ??

thanks

interface ATM1/0.145 point-to-point

ip address 1xx.1xx.2xx.xx 255.255.255.252

no ip directed-broadcast

pvc 1/45

vbr-nrt 8000 8000 100

Router(config)#int a1/0.145

Router(config-subif)#pvc 1/45

Router(config-if-atm-vc)#service

Router(config-if-atm-vc)#service-policy out AV

Router(config-if-atm-vc)#^Z

Router#sh pol int a1/0.145

Router#

2 REPLIES
VIP Purple

Re: why policy is not showing on config ??

Hello,

which platform and which IOS are you using ? You might want to have a look at the following document:

http://www.cisco.com/warp/public/121/where_policy.html#1

Regards,

Georg

Community Member

Re: why policy is not showing on config ??

it is 7206 vxr ver 12.0(7)XE1

I follow the 75 % max reserve-bandwidth rule and it took the command, but never shows up

if the sub-intrface shut down, the policy shows.

PA3 is support on this platform.

Not get it

82
Views
0
Helpful
2
Replies
CreatePlease to create content