Why the Cat 5500 switching engine keeps on deleting the route processor?
My 5500 (Cat OS 4.4(1) has a RSM (IOS 12.0(10)W5(18a) - Enterprise version) installed and MLS is enabled for inter-vlan traffics. It was working fine for over 1.5 years and lately it started to give me the following:
MLS-5-ROUTERDEL: Route Processor [XXXX] deleted -
Then about 5 to 10 seconds later:
MLS-5-ROUTERADD: Route processor [xxxxx] added
Whenever this happens, my users got connectivity problems untill I manually cleared all the MLS entries.
What is (are) the cause(s) of this? and what should I do to prevent it from happening again?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.