why the eigrp cannot resotre automatically after the PVC connection restore
I configure a 3600 router with eigrp and default route to connect another 3600 router with the PVC and a internet circuit.at the normal circumstance,the best route choice is going through PVC by running eigrp,but sometime traffic will transfer to the internet upstream when the PVC circuit encounter problems.after the PVC is restored,the traffic still passing through from the internet upstream,I wonder why the traffic have no jump back to PVC,every time I have to manully change the configuration in my local cisco3600 router,first NO NETWORK ***** IN ROUTER EIGRP 333,then NETWORK ****,this traffic will be transfer to the PVC
Re: why the eigrp cannot resotre automatically after the PVC con
It's difficult to say much without more information. What you could do is to see the routing table once the primary has gone down. See how the route to the remote destination is learnt and check if there is a reason why once installed, the secondary route might be considered more favourable as compared to the primary. I have seen this happen with BGP.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...