Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

wic-1dsu-t1-v2

Help, I'm being driven to madness over a simple point to point connection. The connection will come up and run perfectly with no errors until you reboot a router on either side and more often then not the connection will not resynch until both routers have been rebooted. I've tried 12.3 and 12.2 code, swapped cards all with the same result. If I put the card into loop on the front of the card the connection comes up immediately.

1 REPLY
Silver

Re: wic-1dsu-t1-v2

If you have a back to back connection, one of the routers must have clock source internal and the other must be line. If the

provider if giving clocking both routers must have clock source line if not then one must have line and the other internal.

Below is a link to information about the WIC-1DSU-T1-V2

http://www.cisco.com/warp/public/cc/pd/rt/1700/prodlit/wicds_ds.pdf

248
Views
0
Helpful
1
Replies
CreatePlease to create content