Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WIC-1T and WIC-2T

What is difference between a WIC-1T and a WIC-2T used on the NM-1FE2W, and what is the max speed supported by it

1 REPLY
Anonymous
N/A

Re: WIC-1T and WIC-2T

WIC-2T Sync support with a max speed of 2.048 Mbps

Supports one port at 8 Mbps when used in NM-1FE1R2W, NM-1FE2W, NM-2FE2W, or

NM-2W or 2600 chassis WIC slots. All other WIC ports on that network module or 2600 chassis

must not be used.

Supports two ports at 4 Mbps each when used in NM-1FE1R2W, NM-1FE2W, NM-2FE2W, or

NM-2W or 2600 chassis WIC slots. All other WIC ports on that network module or 2600 chassis

must not be used.

WIC

Supported WICs: WIC-1T, WIC-2T, WIC-2A/S, WIC-1B-S/T, WIC-1B-U,

WIC-1DSU-56K4, WIC-1DSU-T1, WIC-1ADSL

Supported VWICs: VWIC-1MFT-E1, VWIC-2MFT-E1, VWIC-2MFT-E1-DI,

VWIC-1MFT-T1, VWIC-2MFT-T1, VWIC-2MFT-DI, VWIC-1MFT-G703,

VWIC-2MFT-G703

Supports a maximum of two channel groups per VWIC. Does not support ISDN PRI.

Not Supported: WIC36-1B-S/T, WIC36-1B-U, WIC-1B-S/T-LL, WIC-1ENET

Uses Siemens DSCC4 serial controller

Supports bisync

Supports async on WIC-2A/S, WIC-2T

Supports 8 Mbps aggregate across 4 ports. Support for speeds above 4 Mbps must use

WIC-2T.

WICs are not hot swappable. The network modules support hot swap in the 3660.

291
Views
0
Helpful
1
Replies