I have Cisco 1760 router with Cisco IOS 12.3(2)XC2 (proper version for wic-4esw) and one WIC-4ESW installed.The Router does properly recogniza card and even allows to configure it, but when I issue command - NO SHUT - on any of card's interfaces, card stops responding and I get info message:
%ESWMOD-3-NOT_RESPONDING: Ethernet Switch Module is not re
I think the problem is with ESWMOD hardware failure. Because as you said whenever you are trying to activate the card through "no shut" command, it's giving that error message. After reloading the router means your prev configuration of "no shut" command is not saved, that means after reloading the card is being brought to shutdown and so no error message.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...