Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WIC DSU T-1 Configuration

How do you show the existing DSU setup and make changes to it via the CLI?

1 REPLY
Gold

Re: WIC DSU T-1 Configuration

Installing a WIC-1DSU-T1 creates a serial interface on your router, commonly Serial0/0 but the numbering will depend on your particular installation and router model. The physical layer T1 configuration is done via a series of 'service-module t1' commands under that Serial interface. Encapsulation and IP configuration is accomplished as you normally would. The below URL has an example as well as links to more information:

http://www.cisco.com/warp/public/107/wic-1dsu-t1.shtml

77
Views
0
Helpful
1
Replies
CreatePlease login to create content