I have just set up a 2691 running IOS 12.2(8)T5. I have two T1 serials coming in on a WIC 2T with PPP multilinking configured with our ISP. When I run a show interface on the serials, the bandwidth is reported as 2048 Kbits for each T1. My engineer at my ISP says that this is the bandwidth for an E1 not a T1. Our connections work fine, but for monitoring purposes I would like the correct bandwidth to be reported. Any ideas?
The number entered after the bandwidth statement is also used by OSPF and EIGRP for metric calculations. Be sure that you understand how changing this is going to affect the traffic flows in your network.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...