Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Windows 2000 and 6509 w/MSFC

I am just getting started with Cisco products in depth and have run into a wall with something. I currently have a 250+ user network, 2 subnets and a 6509 switch with MSFC module, fiber between buildings with 3500XL switchs on those ends. I have just set up Ghost Multicast Server on a Windows 2000 box and have successfully configured the 6509 to multicast between subnets and Vlans. I cannot, however, see my 2000 box in Windows from the other subnet. I enabled ip forward-protocol udp netbios-ss on the 6509 but didn't help any. I could use some suggestions. I am not up to par in windows 2000 networking, my main server is a Novell 5.1 for which I have tons of experience and certifications in. This is my first attempt at a 2000 box. Thanks...

Brandon

4 REPLIES
New Member

Re: Windows 2000 and 6509 w/MSFC

removed---

New Member

Re: Windows 2000 and 6509 w/MSFC

????? Why removed?

New Member

Re: Windows 2000 and 6509 w/MSFC

I removed it because, my update was irrelevant to your question. I re-read your question and had to remove my update. :)

New Member

Re: Windows 2000 and 6509 w/MSFC

I don't know what you meen by "I cannot see my 2000 box in Windows", but if you can connect to your 2000 box from the other subnet by IP-addressing and you just don't see the box in your network environment it has perhabs something to do with WINS. Make sure the systems connect to the same WINS-server or insert static entries.

98
Views
0
Helpful
4
Replies