I need some help on a design issue. I have a wiring closet with at least 10 Catalyst 2924's in it. I need to know what it the best way to connect all them. The scenerio is this: A 1750 Router connected to port one of switch 1. I then put all the crossovers into the following ports. Port 2 would go to port 1 on switch 2. Port 3 would go to port 1 on switch 3. I follow this till I have all of the crossovers patched into the top switch. I would like to know if this is recommended or should I link them another way. Your thoughts and suggestions would be greatly appreciated. Thanks,
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...