Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WLSE not showing reports

WLSE 2.0.2 software running on an 1105. When I go to Administration, Discovery, Run Now, I put in my seed device and hop, press finish and get a message indicating the report ran. I press okay, and go to view the reports but they are not showing. The last discover I ran was #34. Subsequent reports should be 35, 36, etc... but they don't show. Any ideas?

  • Other Network Infrastructure Subjects
4 REPLIES
New Member

Re: WLSE not showing reports

It takes a while for it to show up. Once 34 completes, then you can see 35 and so on and so forth.. How long has it been ?

New Member

Re: WLSE not showing reports

it's been a couple of hours. I'm only discovering 1 AP and 1 switch. Discoveries 31-34 were instantaneous.

New Member

Re: WLSE not showing reports

Are you sure about the SNMP community string ? Are you able to see those devices in the managed / unmanaged devices list ?

It'll be easier to work on this with a TAC case.

New Member

Re: WLSE not showing reports

I did the SNMP reachability test and it showed SNMP objects for the switch and AP. I don't see the devices in the managed/unmanaged devices list. I have a TAC case open. They want me to upload some log files on Monday. I think the TAC engineer is stumped too.

88
Views
0
Helpful
4
Replies