I have catalyst 5505 with 2 supervisorIII card configured as standby with firmware ver 3.1(2) and CATOS cat5000-sup3.4-1-2.bin with 32MB DRAM and 8 MB on board Flash.
I tried to upgrade image to cat5000-sup3.5-5-10.bin
image is uploaded properly accrodingly set boot sytem command is enterd.
on reseting the module, it is not booting, displays following message:
*** TLB (Load/Fetch)Exception. ***
Access address =0xc
Pc=0x8002f64, cause 0x8008 , Status reg =0x24419922
monitor: command boot aborted due to exception.
can nay body help me?
As I know, since firmware ver is 3.1, we cant go for console download,If I need to reload the image, i feel i will need a pc flash card, can I use 1600 router pcmcia flash card to write the image from working supervisor and boot the standby one using boot slot0 command,
Also Is it possible to download the image to standby supervisor which is in ROmmon mode, from the active supevisor?
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...