We have a CAT5500 with a ATM module that is running on IOS 12.0(19)W5(23). When i do a "show interface ATM 0" i see that the output rate on the interface is very variable. At one moment it is 200Mbit and the next moment it is only a few 100Kbit. I also measuring the interface with MRTG and i see a very bursting traffic graph. So i have the feeling that the counters are not correct on this interface.
Not sure what problem you are anticipating from the output. I guess it might depend on the class of service that you are using on the device. If you have access to Bug toolkit, you can check if there are any known issues with the hardware and software that you are using.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...