The front panel on the Switch Fabric Module has a 2-line by 20-character LCD display. The display allows you to monitor the module's input/outport port traffic and local bus traffic. The display also shows system information.
Two push button switches control the LCD display:
SELECTThis switch is used for LCD display menu selection.
NEXTThis switch is used to scroll to the next item on the LCD display menu
You can configure an lcd banner, using the command "set banner lcd "
The following example shows how to modify the LCD banner for the Switch Fabric Module:
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...