Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WS-X4148-RJ

Hi!

I have a Catalyst 4006, with this configuration:

1000BaseX Supervisor WS-X4013 5.4(1) 6.1(1)

Router Switch Card WS-X4232-L3 12.0(7)W5( 12.0(10)W5(18f)

10/100BaseTx Ethernet WS-X4148-RJ

I will do upgrade in my physical network to category 6 cabling.

I have a doubt, if my actual configuration support new category 6 cabling.

May I upgrade Catalyst too?

Thks,

Paulo

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: WS-X4148-RJ

Hi Paulo,

You don't need to upgrade anything on your switch just because you are now using Cat6 cabling. It should work just as well (if not better) than it did with Cat5/Cat5e cabling...

Hope that helps - pls rate the post if it does.

Paresh

2 REPLIES
Purple

Re: WS-X4148-RJ

Hi Paulo,

You don't need to upgrade anything on your switch just because you are now using Cat6 cabling. It should work just as well (if not better) than it did with Cat5/Cat5e cabling...

Hope that helps - pls rate the post if it does.

Paresh

New Member

Re: WS-X4148-RJ

Thks Paresh.

Paulo

155
Views
0
Helpful
2
Replies
CreatePlease login to create content