Our customer has a Cat6509 switch with one faulty WS-X6148-RJ-45 module. The "show module" commands shows there is an sub module WS-F6K-PWR on it. Can I order a replacement module to WS-X6148-RJ-45 together with PoE sub-module (for ex. WS-X6148-RJ45V) in order I could avoid removing and installing the WS-F6K-PWR from and to the WS-X6148-RJ-45 during its replacement at customer premises?
As per the datasheet aval both the card are similar except u have the upgrade option in the WS-X6148-RJ-45 module to the PoE DFC.
But the later module comes up with a PoE DFC inbuilt..
WS-X6148-RJ-45 : Cisco Catalyst 6500 Series 48-Port 10/100 RJ-45 Classic Interface Module; upgradable to support Cisco Prestandard PoE Daughter Card (part number WS-F6K-VPWR=) or to IEEE 802.3af PoE daughter card (part number WS-X6148-45AF-UG=)
WS-X6148-RJ45V : Cisco Catalyst 6500 Series 48-Port 10/100 RJ-45 Classic Interface Module with Cisco Prestandard PoE Daughter Card (that is, includes daughter card [part number WS-F6K-VPWR=])
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...