Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

X.25 pvc to svc mapping

Hi

I want to find people who have a experience with mapping X.25 pvc to svc and to XOT tunnels in cisco routers

miroslaw.pomian@pl.ibm.com

  • Other Network Infrastructure Subjects
1 REPLY
Bronze

Re: X.25 pvc to svc mapping

To configure a switched PVC to SVC circuit for a given interface, use the switched version of the x25 pvc interface configuration command.

x25 pvc number1 svc x121-address [flow-control-options] [call-control-options]

The following is a typical way to configure the XOT tunnel.

x25 routing

!

interface Tunnel1

tunnel source

tunnel destination

!

interface Serialx/y

encapsulation x25 ietf

x25 htc 5

lapb k 2

!

x25 route interface Serial x/y

x25 route xot xot-source Tunnel1

You can go thruogh the command reference guide :

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fwan_r/x25cmds/wrfx252.htm#1030874

90
Views
0
Helpful
1
Replies
This widget could not be displayed.