We are using a Cisco 2600 to convert incoming X25 streams from Point of Sale terminals to IP. These arrive via an XOT stream via satellite. The satellite system connects to a router in our processing centre as XOT, then is passed as straight X25 to the 2600 where the translation to IP occurs.
The basic translation seems to work OK and POS terminals are able to authorise payments (small amounts of data). However, at the end of the day, the merchants using POS terminals upload there daily transactions, and if there are more than three messages, the upload fails and data is corrupted. We have checked window sizes and max packet sizes etc.
The 2600 gives no error messages from debug. I have tried debug x25, and debug x25t events, all we see is a call clear or call failed, but no indication why.
Having connected a serial analyser however, it appears that data is being "echoed back" to the POS terminals, they get confused, corrupt the data and clear the call.
I suspect that this is a translation configuration problem, but cannot find any reference to it in the X25 commands.
We used to use an old Gandalf protocol converter for this, and this does not show the same problem.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...