Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

X25 SVC 0

We are trying to configure a serial interface in X25.

Our X25 subscription specifies that SVC 0 is used. All the X25

CISCO commands to configure the SVC range start with SVC 1, how is

possible to configure the cisco in order to use SVC 0 ?

I didn't found more informations on the cisco web site.

The x25 virtual circuit ranges configuration parameters can range from 1

to 4095 and virtual circuit 0 is not available.

In an x25 network the Logical Channel Number 0 (svc 0 in switched X25

environnement) can be USED (used by the network to carry only the

diagnostic packets) or can be UNUSED (available for use as others LCNs

numbers) and for example, in an IBM x25 NPSI sofware this option can be

specified.

Can somebody tell me if I can use the SVC 0 ?

Thanks in advance for your help!

1 REPLY
New Member

Re: X25 SVC 0

I finally found the command !!!

"x25 subscribe lc0 two-way"

It seems to solve the problem.

But I do not understand why there are such masked commands.

95
Views
1
Helpful
1
Replies