06-25-2002 03:22 AM - edited 03-01-2019 10:33 PM
Hi,
I have a problem with X25 to TCP/IP translation on links that do not send an x121 address in the call-setup.
Is there a way of using an X25 profile to insert a dummy source and destination address so that the translation mapping will work?
I am using a 7206 router running 12.2.8(T) and using RBP to do the translation.
Thanks
07-01-2002 10:29 AM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
07-01-2002 11:17 AM
Richard - which end is initiating the call - TCP or X25?? If its TCP, then you can use the below:
interface serial x/y
x25 map rbp
!
x25 route
If its X25 incoming, then would need a destination X25 address in the CALL REQ packet for SVC setup, or else use X25 PVCs!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: