Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

X25 to TCP/IP translation

Hi,

I have a problem with X25 to TCP/IP translation on links that do not send an x121 address in the call-setup.

Is there a way of using an X25 profile to insert a dummy source and destination address so that the translation mapping will work?

I am using a 7206 router running 12.2.8(T) and using RBP to do the translation.

Thanks

  • Other Network Infrastructure Subjects
2 REPLIES

Re: X25 to TCP/IP translation

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Bronze

Re: X25 to TCP/IP translation

Richard - which end is initiating the call - TCP or X25?? If its TCP, then you can use the below:

interface serial x/y

x25 map rbp local

!

x25 route subsitute-source interface serial x/y

If its X25 incoming, then would need a destination X25 address in the CALL REQ packet for SVC setup, or else use X25 PVCs!!

206
Views
0
Helpful
2
Replies
This widget could not be displayed.