Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1601 booting process

Our Cisco 1601 router is repeatedly failing to resume operations normally whenever powered off or each time after power failure! It constantly boots in ROM Monitor mode and we always have to reset before operations resume normally. Any thoughts/advice about this unusual behavior? Thanks in anticipation.

Joe Pac.

5 REPLIES
New Member

Re: 1601 booting process

You have probably checked this but what is your config-register set to ?

The "normal" boot value is #2102

Regards

John

New Member

Re: 1601 booting process

boot value should read 0X2102 sorry, where did that # come from !

New Member

Re: 1601 booting process

Thanks John for your replies. However, the boot value (config-register ) reads exactly 0x2102, reason why the reported behavior is confusing me!

Thanks again for any other comment!

Joe P.

New Member

Re: 1601 booting process

Verify that no console cable is connected to the router when rebooting.

New Member

Re: 1601 booting process

Dear BSeddik,

Thanks for your reaction. Inded, the behavior was observed while a console cable attached to the router.

Regards,

JPac.

109
Views
0
Helpful
5
Replies