I have configure the VPN on a router which contains two interface ATM, but the probleme it is that I cannot attenidre the seconde be cause i have configure an IP ROUTE 0.0.0.0 0.0.0.0 Dialer 0 I know not how how to share the load (c-?-d the half of the customers connects the 1st line and the others connects 2eme lines)
If you want to have policy based routing based on the source address you can go for source based routing and defining the exit interface or gateway which you would like the source ip address to use to go out.
Do confirm the kinda requirement you have in place and also the current config of your router so that we can suggest accordingly..
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...