I need to setup a Pix to Pix to Pix mesh. I've been trying to establish a connection between 2 of the devices for the past 3 days and I'm hoping I an get a bit of help. I've followed the pix to pix to pix mesh guide at http://www.cisco.com/warp/public/110/pixmeshed.html but to no avail.
Here are the configs for 2 of the pix's the third I'll gain access to on Monday.
As you can see the Largo one is also in use as a VPN device for client VPN's also.
Currently I have debug turned on but I'm not getting any info from that. I've also
Any help is greatly apreciated.
I currently have debug crypto ipsec sa and debug crypto isakmp sa running but I'm not seeing anything, and the output of the show crypto ipsec sa command blank and the show crytpo isakmp sa command show no devices listed at all.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...