2610 boot process

[jpac]

My 2610 is unable to boot after a power ouitage. Suspect some hardware issue. Continously displays the following output. Any thoughts or tips?

Thanks.

Joe Pac.

%SYS-6-READ_BOOTFILE_FAIL: flash:c2600-i-mz.122-2.T File read failed -- .

%SYS-6-READ_BOOTFILE_FAIL: tftp://172.16.8.2/c2600-i-mz.122-2.T File read fail

ed -- Timed out.

%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.

boot of "c2600-i-mz.122-2.T" using boot helper "flash:c2600-i-mz.122-2.T" failed

error returned: File read failed -- Timed out

loadprog: error - on file open

boot: cannot load "c2600-i-mz.122-2.T"

[j-block]

At rommon, do a dir flash: and make sure the image on flash is okay. If it is, type boot flash: . This should bypass any boot system statements which could be causing problems. If the router boots, be sure your boot system statement (if any) is valid. Actually, if there's only one image in flash, there's no need for a boot system statement. In that case remove any boot system statements.