Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

30 channels of 64 K to give 2 MB channelised interface.

WE have got a central location with a 3640 router.

We are getting 30 64 K lines coming in from 30 locations.

Can we aggregate these 30 nos 64 K lines at the leased line service provider and get it to our premises over a 2 MB link and place it into the

1 port channelised E1 ISDN PRI card.

We should be able to assign saperate IP address to each of the channel of this channelised 2 MB.

THus we wish to create a WAN with 30 different location from the central office but use only 1 no. of 2 MB modem at teh central location, instead of 30 nos of 64 K modems.

MAngesh

2 REPLIES

Re: 30 channels of 64 K to give 2 MB channelised interface.

The focus of this board is Virtual Private Networks, however, there are a number of professionals online who may be able to assist you. We are always considering additional forums for such topics and I will make a note of your post.

If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: 30 channels of 64 K to give 2 MB channelised interface.

116
Views
0
Helpful
2
Replies
CreatePlease login to create content