I'd like to setup an older 3000 series concentrator we have here, however I don't have the credentials. The issue I'm having is that I can't get any response from the console. I'm using the proper RS232 cable and have setup a session using 9600-8-1-N. I can't get any output from the device.
I know it's active as I can SSH and browse to the devices logins.
Are you using a straight through Serial cable , I use serial DB9 female to RJ-45 adapter at each end for connecting to VPN console port and PC serial port, you may use a regular straight through CAT5 cable if you do have the female DB9-RJ45 adapters.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...