Can you use a dynamic external ip address with the 3002 hardware client, or does it have to be static? I'm assuming you can use one in client mode, but what about in network extension mode? Also, I just wanted to verify that an external switch or hub can be used with the single internal port version in order to support multiple hosts. The 3002 Q&A page was a bit unclear on this.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...