Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3002 not keeping password after powering off

We have been deploying some new 3002 VPN client hardwared devices. When they power off or temporarily lose power they do not reconnect as the password information is not being held. They are set up and saved just like our previous deployed units that are not having this problem. Anyone encounter this before? If so, any suggestions would be helpful.

Thanks!

2 REPLIES
Cisco Employee

Re: 3002 not keeping password after powering off

Are you talking about the group password or the user password? If the group password then honestly I have no idea, will do some more research if you reply back telling me so.

I'd be more inclined to think it's the user password, in which case are these new 3002's connecting into a different group on the head-end concentrator as your previously deployed units? Under the group settings under the Client Config tab on the head-end concentrator there's a setting called "Allow Password Storage on Client", this needs to be checked for the 3002 (or any SW client) to be able to store the user password.

New Member

Re: 3002 not keeping password after powering off

Thanks for the response. Unchecking the local storage of password was the solution. Keeping it on the concentrator seems to have been the fix.

95
Views
0
Helpful
2
Replies