Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

3140 NAC

New install of 3140. I already have CAM setup and now setting up CAS in OOB VG. Just want to make sure as cco doc statest E0 is trusted and E1 is non-trusted. However, 3140 has physical E1 and E2 interface.

1. Can I assume that physical E1 is actually cco docs equivalent of E0?

2. Assuming topology:

Core6506(Layer3)--trunkVlan99Only-2970switch--EndDevice

Do I put the 3140CAS in the following manner:

Core6506(Layer3)--(E1)CAS(E2)-2970switch--EndDevice

TIA

1 REPLY
Silver

Re: 3140 NAC

I think it's ok but before you proceed make sure the conmpatibilty matrix and configurations are correct .

93
Views
0
Helpful
1
Replies
CreatePlease to create content