I want to be abled to connect 5x 827 DSL Routers to a single 506E. Why you ask! I have a central Site that will become a Terminal Server Farm and multiple remote sites that will vpn in via their own 501's to the 506E. Each of the 5 routers will have their own IP 29 bit ip range. The Question is how do I set the 506E to use different routers for each of the remote sites. Yes a faster link would be a better solution rather than having 5 DSL routers but for too many reasons I am stuck with trying to make this solution work. All assistance greatly Appreciated.
Thanks for the info however I'm not sure if I explained myself fully.
At the central site I will have a PIX 506E.
The remote sites will have PIX 501's.
The 506E will be connected to the lan interfaces of 5 Cisco 827 DSL routers. So the central site has 1 PIX and 5 Routers.
Each of the routers will have their own 29bit internet IP address.
The remote sites will be connected to the net using Dynamic ADSL connections with their 501 PIX's establishing a VPN connection to the central sites 506E. Making it a Dynamic to Static VPN which I can do.
Do I just set up nat on the routers and give a single ip to the 506E's external interface if so do I make the 506E send vpn traffic for site A through router A and vpn traffic for site B go through Router B?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...