Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

515E Not Booting - After Upgrade..

When i upgrade from 6.35 to 7.04 - my pix doesnot boot. it stops saying reading from Flash.. I did the upgrade using copy ftp flash command as said in the document. My PIX has the recommended hardware requirements.

Any help will be appreciated..

Regards,

Prakash Athrayil

7 REPLIES
New Member

Re: 515E Not Booting - After Upgrade..

Does your 515 meets the minimum memory requirement (128Mo) for this upgrade.

Please check the following:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/prod_bulletin0900aecd8023c8d4.html

Good luck!

Mike

New Member

Re: 515E Not Booting - After Upgrade..

Oops! Sorry forget my last email.

Another thing, somebody in this forum has already provided a solution for this error. He removed and replaced jumper#5 (JP5) on the pix board.

I actually did not try his recipy but you may find the complete information on this forum.

New Member

Re: 515E Not Booting - After Upgrade..

I am in a remote location. It is not possible to open the Box. Is there any method please ..

New Member

Re: 515E Not Booting - After Upgrade..

Is the console port available? and can you boot the PIX in monitor mode only.

New Member

Re: 515E Not Booting - After Upgrade..

The console port is available and while booting it stays saying Reading from Flash..

i am not able break the sequence while booting ..

and also i tried booting with boothelper. in this case it boots and after i upload the older version of software from tftp and it gives a error called

Watchguard .....failure.........

Contact customer support ...

and it reboots automatically..

New Member

Re: 515E Not Booting - After Upgrade..

Contact TAC at www.cisco.com

New Member

Re: 515E Not Booting - After Upgrade..

Their rates are not affordable in my current business condition.. I may have take help from somebody..

Thank You..

147
Views
0
Helpful
7
Replies
CreatePlease to create content