Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

6.3 killed pix 515e

Hey,

I tried to install 6.3 on my pix515e from version 6.2.1 and it just killed it. It repeatedly failed over about every minute and had no access from inside out on one of the interfaces. when it was up for the minute, my outside in rules worked fine but still no one on interface 2 could get out. I also installed the latest version of the pdm. Luckily I just pushed it ack to 6.2.1 and it is back to normal. Any thoughts from anyone.

Thanks

Jim Kiddoo

  • Other Security Subjects
2 REPLIES
New Member

Re: 6.3 killed pix 515e

My install of 6.3(1) worked okay, but when I tried to use PDM 2.0(2), it said it needed a new image. When I tried a new PDM 2.1(1), it STILL says I need a new image. Do you have any experience with that?

Mike

New Member

Re: 6.3 killed pix 515e

you have to install the 3.0 pdm which is in beta. You can get it off the cisco software

89
Views
0
Helpful
2
Replies
This widget could not be displayed.