I tried to install 6.3 on my pix515e from version 6.2.1 and it just killed it. It repeatedly failed over about every minute and had no access from inside out on one of the interfaces. when it was up for the minute, my outside in rules worked fine but still no one on interface 2 could get out. I also installed the latest version of the pdm. Luckily I just pushed it ack to 6.2.1 and it is back to normal. Any thoughts from anyone.
My install of 6.3(1) worked okay, but when I tried to use PDM 2.0(2), it said it needed a new image. When I tried a new PDM 2.1(1), it STILL says I need a new image. Do you have any experience with that?
