Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

A PIX Command to SHOW RUN brief

Right now my pix will show the entire config in one fail swoop. I need to break it down to so many lines. I've tried goggling it but no such luck so far. I need to change it and make it permanent so that every time I open it up it will stay at that level?

Please give me a link to the proper command or a suggestion on how to do this?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: A PIX Command to SHOW RUN brief

Hi,

In Pix 6.x, you could use

Pager

http://www.cisco.com/en/US/docs/security/pix/pix63/command/reference/mr.html#wp1026890

In Pix 7.x and higher,

Terminal pager

Regards,

Arul

*Pls rate if it helps*

9 REPLIES
Cisco Employee

Re: A PIX Command to SHOW RUN brief

Hi,

In Pix 6.x, you could use

Pager

http://www.cisco.com/en/US/docs/security/pix/pix63/command/reference/mr.html#wp1026890

In Pix 7.x and higher,

Terminal pager

Regards,

Arul

*Pls rate if it helps*

Community Member

Re: A PIX Command to SHOW RUN brief

Thanks for the Help it did resolve it. Sorry I forgot I made the request for assistance.

If at all possible how would I make it permanent. I've done this and after so many connections I have to do it again.

Re: A PIX Command to SHOW RUN brief

After you make the change, you should be able to write the config to make it permanent.

HTH,

John

HTH, John *** Please rate all useful posts ***
Community Member

Re: A PIX Command to SHOW RUN brief

Unfortunately that did not work, after a couple of days it defaults to showing all of it at once.

Any other suggestions?

Re: A PIX Command to SHOW RUN brief

Not really. It's part of your config, so writing it should keep the changes. If you're losing the changes, I think you have a larger problem.

If you do a "sh run | inc pager", what do you see?

What version are you on, and what PIX version is this?

HTH,

John

HTH, John *** Please rate all useful posts ***
Community Member

Re: A PIX Command to SHOW RUN brief

I see the following.

PIX525# sh run | inc pager

pager lines 30

PIX525#

Cisco PIX Firewall Version 6.3(4)

Cisco PIX Device Manager Version 3.0(3)

Re: A PIX Command to SHOW RUN brief

If you change that to what you want, and do "sh run | inc pager" again, do you see the changes?

If so, you should do "wr mem". After that, try "show start | inc pager" and see if your changes are there. If they are, you shouldn't be losing the changes on reboot.

HTH,

John

HTH, John *** Please rate all useful posts ***
Community Member

Re: A PIX Command to SHOW RUN brief

Okay lets see, and I will let you know in a few days.

Thanks

Community Member

Re: A PIX Command to SHOW RUN brief

Just to keep you updated, I did the wr mem and it kept it for awhile. After awhile it reverted back. It there something else I should be looking at?

313
Views
5
Helpful
9
Replies
CreatePlease to create content