I configured IAS(RADIUS) on IIS4.0(option pack) & cisco AS2511RJ as NAS.I put radius only as the authentication method & every thing works perfectly except AAA accounting.AAA accounting does not create any logs on the NTserver.(I checked all the basic checks).
Also I am not sure about the entries on the vsa info.(vendor specific attribute).[note that I am using IIS4.0].
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Just turning radius on in the cisco does not turn accounting on, or authorisation on. So you need to make sure that the NAS config is built on "AAA new- model", and has the line "AAA accounting network start-stop radius". Please check the format of that last command, I'm re-calling from memory (eek).
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...