Carl, what error message are you geting? when you create a user account under device administration you also need to configure or enable LOCAL Authentication/Authorization under Device Access > AAA access.
Hi there, basically when i set up the user in adsm its ok, but when i come to apply it, it come up with an error, and gives me the option to resend the command. also i have got authentication enabled but not authorization, i was told i dont need to enable authorization as the option for priviledge levels can be set on the user setup
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...