I have set up an ASA 5520 that will allow us to authenticate via SSH using Cisco Secure ACS. My issue is that once you ssh into the inside interface of the device, it will ask you for a login. I type in my domain account login and I SSH just fine. My issue lies when I attempt to use enable mode. When trying, I noticed in the syslog that everytime I tried my enable password, the syslog would say my domain account has been denied. Is there a way to fix this? I guess if it is happening on the ASA/Pix, it will happen on routers and switches as well.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...