Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

access-list in Catalyst 2948G-L3

Can I apply access list in the interfaces FastEthernet or BVI in a Catalyst 2948G-L3 ?

I have read the documentation an the answer is not.

But if I am in the configuration mode in the catalyst, and a configure a interface FastEthernet I can write " ip access-group ..... " Will it take any effect ?

Thank you.

2 REPLIES
New Member

Re: access-list in Catalyst 2948G-L3

Yes you can - download the latest IOS for the 2948G-L3 - I have configured access-lists on a 4908G-L3

New Member

Re: access-list in Catalyst 2948G-L3

You can't apply ACLs on Fastethernet or BVI interface on a cat2948g-l3

http://www.cisco.com/univercd/cc/td/doc/product/l3sw/4908g_l3/ios_12/18w522a/config/acl_cnfg.htm#xtocid283371

"ACLs are supported only on Gigabit Ethernet ports and corresponding Gigabit Ethernet subinterfaces.

ACLs are not supported on Bridge-Group Virtual Interface (BVI), Fast EtherChannel (FEC), Gigabit EtherChannel (GEC), and Fast Ethernet interfaces

117
Views
0
Helpful
2
Replies
CreatePlease to create content