I have just installed a PIX 525 to replace a classic. When you issue a conduit statement on the classic, it automatically grouped the ip addresses together. I am now using ACLs on my new PIX. Is there any way for it to group my ip addresses instead of putting them to the bottom of the ACL. Especially the destination address?
There is a new feature in the 6.3 PIX OS that allows you to insert acess-list entries into a specific point of the acess-list. If you are using the 6.3 release, issue the access-list command for the syntax of this feature.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...