Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

access-list statement on PIX does not show up - why?

I am creating a access-list on the PIX and when I do a show access-list or show run It will not display. If I do a show access list 202 it displays. The firewall is at 6.3(3). I've tried saving the config and that doesn't help. Any Ideas?

Regards,

Mike

2 REPLIES
Community Member

Re: access-list statement on PIX does not show up - why?

Can you post your console logs ? Helps to understand the issue better.

Community Member

Re: access-list statement on PIX does not show up - why?

Here is the console log messages:

111007: Begin configuration: console reading from terminal

111008: User 'enable_15' executed the 'configure t' command.

111008: User 'enable_15' executed the 'access-list 202 permit ip host 12.12.12.12 host 172.16.13.19' command.

111005: console end configuration: OK

109012: Authen Session End: user 'XXXX', sid 883, elapsed 347 seconds

111001: Begin configuration: console writing to memory

111004: console end configuration: OK

Show run = Access list does not display

Sho start = Access list does not display

Sho access-list = Access list does not display

Sho Access-list 202 = access-list 202 line 1 permit ip host 12.12.12.12 host 172.16.13.19 (hitcnt=0)

Very Strange

Thank you for your input.

150
Views
0
Helpful
2
Replies
CreatePlease to create content