Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Access to multiple subnets via PIX & VPN client 3.11

I have a pix 515 configured to allow vpn access to three subnets: 10.15.0.0, 10.15.107.0 and 10.1.1.0.

I can access hosts on the 10.15. networks, but when I ping anything on the 10.1.1.0 network I timeout. While watching the VPN client statistics, I see packets being sent on all network, but while I see packets being encrypted/decrypted on the 10.15. networks, I only see packets encrypted on the 10.1.1.0 network. Any suggestions?

2 REPLIES
New Member

Re: Access to multiple subnets via PIX & VPN client 3.11

Check the servers on the 10.1.1.0 network to see if they have a path to the network used for vpn clients. It seems that traffic is send to the network, but no responses are seen.

New Member

Re: Access to multiple subnets via PIX & VPN client 3.11

From the pix I can ping the 10.1.1.0 network. The hosts on this network can ping the pix. However, even though the pix is assigning an ip from the dialer pool, I can't ping it from any network!

93
Views
0
Helpful
2
Replies