12-07-2006 08:48 AM - edited 02-21-2020 02:45 PM
I have PIX506 & PIX515's configured as a VPN server but when I connect using the VPN client, I can't telnet or SSH into the PIX itself. Is there a way around this? I hate having to RDP into one of the systems on the LAN and telnet to the PIX from there.
Thanks!
12-07-2006 10:29 PM
Hi
Have you enabled telnet or SSH on your pix ?
Can you post the config related to telnet and SSH here ?
regds
12-07-2006 10:39 PM
To allow you to access PIX when you're in VPN session, check 2 things:
1. Configure telnet,ssh,http (for https)
Example:
telnet xx.xx.xx.xx yy.yy.yy.yy inside
*xx.xx.xx.xx is your VPN IP Pool address/subnet assigned for VPN
2. Allow management access to PIX
To allow management access to an interface other than the one from which you entered the security appliance when using IPSec VPN, use the "management-access" command in global configuration mode.
firewall(config)# management-access inside
firewall(config)# show management-access
management-access inside
HTH
AK
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: