Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ACL on interface or subinterface

I have an ACL applied to an interface, which contains a subinterface. The interface has no IP address assigned, but is up. The ACL does not appear to be capturing any traffic, a sh ip access-list 101 displays no matches. I guess my question is, does the ACL need to be applied to the subinterface for it to be affective.

Serial0/0 is up, line protocol is up

Hardware is PQUICC with Fractional T1 CSU/DSU

MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation FRAME-RELAY IETF, loopback not set

Serial0/0.2 is up, line protocol is up

Hardware is PQUICC with Fractional T1 CSU/DSU

Description: Verizon Business MPLS Circuit atlanta-ga Internet address is x.x.x.x/30

1 ACCEPTED SOLUTION

Accepted Solutions

Re: ACL on interface or subinterface

put the ACL on the sub-interface.

1 REPLY

Re: ACL on interface or subinterface

put the ACL on the sub-interface.

321
Views
0
Helpful
1
Replies
CreatePlease to create content