Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ACS 3.2.1 - Evaluation Software Problems

Hi,

I've been experiencing problems with ACS 3.2.1 Eval software using Aironet Radius as authentication for Aironet Clients using PEAP Authentication. PEAP settings dissappear after Certificate has been installed and the Authority has been setup. After restarting ACS etting up of the PEAP settings ACS warns that a Certificate has not been installed.

H/W: Dual Processor Pentium III Xeons; 512MB Memory,

19GB Hard Drive

Software Specs: Windows 2000, Service Pack: 4

Any known issues?

2 REPLIES
Bronze

Re: ACS 3.2.1 - Evaluation Software Problems

Check out the following release note for the evaluation software for known issues,

http://www.cisco.com/en/US/products/sw/secursw/ps2086/prod_release_note09186a008018492b.html#1046573

New Member

Re: ACS 3.2.1 - Evaluation Software Problems

This document provides no information that I could see on the issue presented here. I, too, am having the same issue where the ACS server accepts the cert, and then fails to recognize it when trying to enable PEAP.

If anyone has solid information about this, please point us to it.

212
Views
0
Helpful
2
Replies
CreatePlease to create content