Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ACS error "dnis:974xxxx" authorization failed

After successfully implementing Cisco Secure ACS v2.6, I noticed an error in the "FAILURE" logs for one of the 5300s. It states "dnis:974xxxx Authorization failure...user unknow". This device pools lines into an ISDN incoming line. It seems everytime a the ISDN is reset, maybe 20 times a day, this error appears in the log. Has anyone seen this before? If so, did you notice any problems?

Thanks!

1 REPLY

Re: ACS error "dnis:974xxxx" authorization failed

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

100
Views
0
Helpful
1
Replies
CreatePlease to create content