I was looking for a certain features that was reported for me by some customers. I hope someone has noticed those:
1- When the ACS assign the ip address for the users from a pool defined in the ACS, how can I know which user take which IP. If I check in the report, it shows that the IP address assignment is none and does not show which IP did the user get. It shows in the access server.
2- Can you disconnect a user from the ACS. Purging only delete the accouting but does not disconnect the user. I can disconnect by clearing the line where that user is logged but that is not flexible.
3- In the ACS you can limit the session for the user but when the user disconnect and connnect again he will be in. What I am looking for is away to give the users 3 hours time and then when he consume those 3 hours he cannot log in. You can limit the session to 3 hours but when he disconnect and connect again, he is granted another 3 hours.
Often times advanced configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...