Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ACS v2.6 with Aironet AP

Hi

I have configured my Aironet AP350 for two type of client. Client that are EAP authenticated and client that are MAC authenticated. I want that EAP client have access to all my network resources and that the MAC client have access to only few resources. I can set the access control list on the authentication server for my AP? I configured on my AP a protocol filter and I set it in the IETF RADIUS attribute on the ACS v2.6, but it doesn't work.

Your help will be appreciated.

1 REPLY

Re: ACS v2.6 with Aironet AP

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

115
Views
0
Helpful
1
Replies
CreatePlease to create content