Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACS

hi,

I have Cisco ACS-1113. I want to connect this in existing network.

My query is ACS have two LAN interface. Whats the use of second interface as Cisco documents states "ACS SE supports the operation of either Ethernet connector, but not both connectors".

Thanks

Nilesh

1 ACCEPTED SOLUTION

Accepted Solutions

Re: ACS

It can communicate with other subnets just like any other device. If a device is not on the local subnet, it forwards to the default gateway and off it goes.

Here's a link to the configuration guide-

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_windows/4.2/configuration/guide/acs42_config_guide.html

3 REPLIES

Re: ACS

Currently two NICs are not supported, for example teaming the NICs. You can use either NIC, but only one of them, not both.

Hope that helps.

New Member

Re: ACS

Hi ,

Thanks

Need more advice.

If there is only one NIC in use then how ACS do the communication between two different subnet.

I mean if have configure the Router/switch(which is supposed to manage) with 10.10.10.1/24 subnet & ACS IP as 20.20.20.0/24

I need to introduce ACS for the managing access to network device.

Can you please share the configuration document for the same.

Regards,

Nilesh

Re: ACS

It can communicate with other subnets just like any other device. If a device is not on the local subnet, it forwards to the default gateway and off it goes.

Here's a link to the configuration guide-

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_windows/4.2/configuration/guide/acs42_config_guide.html

165
Views
0
Helpful
3
Replies